Lights Fixing & Lighting Installation
Motion Sensor Lighting in The Oasis by Emaar
Motion Sensor Lighting in The Oasis by The MELLS. Motion sensors switch lights on when someone enters and off after a set delay, in stores, corridors, bathrooms, garages and along villa paths. We visit the property first and confirm the scope in a written quotation.
- Quotation
- Written, after a visit
- Response
- 2 hours in Dubai
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday
Motion Sensor Lighting at a glance
| Service | Motion Sensor Lighting |
|---|---|
| Location | The Oasis by Emaar, Dubai |
| Property types | Mansions and large villas |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | 1 to 3 hours for a few fittings, longer for whole rooms |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | A measured test for every job, with photographs before and after |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Two hours in Dubai for urgent work, planned work within 48 hours |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 55 444 0084 or email contact@themells.ae |
What is included
Light fixing and lighting installation for homes, offices and shops, from one replaced fitting to downlights, LED strip, pendants and outdoor lights. Most lighting faults in Dubai trace back to a fitting screwed into gypsum board alone, a driver with no headroom, or a joint that humidity has reached. Our own technicians isolate the circuit at the distribution board, prove it dead with a tester and work to the manufacturer's instructions. Any approval the building or the community asks for is identified at the site visit, and we prepare the paperwork.
- Sensor type chosen for the space and the mounting height
- Detection zone walked and adjusted so it covers the doorway
- Off delay and daylight threshold set on site
- Manual override left in place where the user wants one
How we carry out motion sensor lighting
A passive infrared sensor sees a warm body moving across its view, so it is placed where people walk across it, not straight towards it. Microwave sensors see through thin partitions and suit enclosed fittings, but need turning down so they ignore the corridor outside. The sensor is wired between the switch and the lights, the delay and daylight level are set, and we walk the room to see that it triggers at the door and holds while someone stands still at a shelf or basin.
Outdoor sensors in Dubai get false triggers from warm air off AC outdoor units, swaying palms and cats on the boundary wall, so aim and sensitivity matter more than the fitting. In summer a passive infrared sensor is also less sharp, since the background is close to body temperature. Indoors, the usual complaint is lights going off on someone sitting still. The site visit checks the mounting height, what the sensor will see and the load it must switch.
How it works
The same method on every job, so the result does not depend on who is on shift.
- Survey and diagnosis. A technician inspects the system or surface, takes readings and photographs, and explains what was found in plain language.
- Written quotation. You receive a written quotation against a defined scope before any work starts. Anything outside that scope is quoted separately.
- Protected, supervised work. The work area is protected and isolated, and the job is carried out by our own technicians under a named supervisor.
- Testing. Every job ends with a measured test suited to the discipline, so the result is a reading and a photograph and not an opinion.
- Report and warranty. The completed report reaches you within the hour. Any failed point is put right free of charge within 48 hours.
Talk to a supervisor about motion sensor lighting today.
Why choose The MELLS for motion sensor lighting
What an ordinary job leaves out, and what you can hold us to.
| Point | An ordinary job | The MELLS |
|---|---|---|
| Quotation | A figure over the phone, with extras added on the day | A written quotation after a site visit, and nothing added on the day |
| Team | Crews supplied through agencies or subcontractors | Crew directly employed by The MELLS, with a named supervisor |
| Method | Parts replaced until the fault goes away | The fault is found, measured and explained before any part is replaced |
| Handover | The job ends when the crew leaves | A measured test for every job, with photographs before and after |
| Aftercare | A return visit is charged | A failed check is put right free of charge within 48 hours |
Our commitments on every motion sensor lighting job
The same standard on a single room or a whole estate.
Written quotation
The scope is fixed in writing before any work begins.
Named supervisor
One person is responsible for your job from the visit to handover.
Checked before handover
A measured test for every job, with photographs before and after.
Put right within 48 hours
If a check fails, we come back and correct it free of charge.
Fully insured
Our work in your home or premises is covered by insurance.
Discreet crews
Uniformed, briefed on your house rules and respectful of your privacy.
Motion Sensor Lighting in The Oasis: what we plan for
The Oasis by Emaar is a large villa and mansion community in the Dubailand belt, reached from Sheikh Zayed bin Hamdan Al Nahyan Street near Remraam, Jumeirah Golf Estates and DAMAC Hills. It is planned around lakes, canals, swimmable lagoons and parks, in districts such as Palmiera, Mirage, Lavita, Tierra by Address, Ostra and Mareva, with handovers planned from late 2027 into 2030.
Lagoons and canals raise the humidity around the homes and bring midges in warm months, while the desert edge sends fine dust over everything after a windy day. New phases will be built for years, so construction dust will be part of life for a while. A first AC service soon after handover removes construction dust, and pool plant and irrigation are checked before the first summer.
The districts are gated. Contractors are registered by the owner, and exterior changes need the developer's or the community's approval.
What your quotation depends on
A quotation for motion sensor lighting in The Oasis follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Size and type of the system or surface
- Present condition and ease of access
- Parts and materials specified
- One visit or a retained contract
Related Lights Fixing & Lighting Installation services in The Oasis
Each one has its own scope and method.
Light Fixing and Replacement
Spotlight and Downlight Installation
LED Strip and Cove Lighting
Pendant Light Installation
Wall Light Installation
Track Lighting Installation
Kitchen and Cabinet Lighting
Bathroom and Mirror Lighting
Staircase Lighting
Villa Exterior and Facade Lighting
LED Lighting Upgrade
Flickering and Faulty Light Repair
LED Driver and Transformer Replacement
Dimmer and Smart Switch Installation
Ramadan and Festive Lighting Installation
Villa Lighting Installation
Chandelier Installation
Ceiling Fan Installation
Garden and Outdoor Lighting
Cove and Bulkhead Ceilings
Motion Sensor Lighting across The Oasis
Questions about motion sensor lighting in The Oasis
What does motion sensor lighting include?
Motion sensors switch lights on when someone enters and off after a set delay, in stores, corridors, bathrooms, garages and along villa paths. The work includes sensor type chosen for the space and the mounting height; detection zone walked and adjusted so it covers the doorway; off delay and daylight threshold set on site.
Can a sensor be added to lights I already have?
A sensor can replace the wall switch or be mounted on the ceiling and wired into the existing circuit. We confirm that it can carry the load of the lights, since LED drivers draw a surge when they start.
Why does my outdoor sensor light keep coming on?
Something warm or moving is crossing its view: an AC outdoor unit, a tree, traffic or animals. We mask part of the lens, lower the sensitivity or move the sensor so it only watches the gate or path.
How much does motion sensor lighting cost in The Oasis?
We do not publish prices, because no two jobs are the same. The main factors: size and type of the system or surface; present condition and ease of access. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides motion sensor lighting in The Oasis?
The MELLS provides motion sensor lighting in The Oasis, Dubai. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.
How long does motion sensor lighting take?
Typically 1 to 3 hours for a few fittings, longer for whole rooms. The time for your property is confirmed with the quotation.
Can a heavy chandelier hang from a gypsum ceiling?
Not from the board itself. The weight has to go to the slab or a joist through a fixing rated for the load, with the gypsum only covering it. We open a small access above the position, set the anchor and close the ceiling around the rose.
Is a permit needed for lighting work in a tower or mall in The Oasis?
Towers and malls normally ask for a work permit, and a retail unit has to follow the landlord fit out guide. We identify what applies at the site visit and prepare the paperwork the building or the landlord asks for.
Should every light in a room be the same colour?
Within one room, yes. Warm white suits living rooms and bedrooms, and neutral white suits kitchens and work areas. Two whites on one ceiling look patchy, so we read the colour temperature printed on each lamp before it is fitted.
How do your crews get access to The Oasis?
The districts are gated. Contractors are registered by the owner, and exterior changes need the developer's or the community's approval.
Do we need Emaar approval for work in The Oasis?
Cleaning, AC servicing and repairs inside the home only need the gate or building pass, which the resident arranges. Exterior painting, waterproofing, fit out and any change to the facade, roof or garden structures need a no objection certificate from Emaar or the community management in The Oasis before work starts. We prepare the method statement, drawings, insurance and trade licence documents the approval asks for.
How do I choose a company for motion sensor lighting in The Oasis?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (a measured test for every job, with photographs before and after) and puts right any failed check free of charge within 48 hours.
Can you come to The Oasis at short notice?
Yes. Crews travel from our Barsha Heights base, and urgent work in Dubai is attended within two hours between 08:00 and 19:00, Monday to Saturday.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.