Al Khalidiyah
Galvanised Steel Ducting in Khalidiya Towers, Al Khalidiyah
Galvanised Steel Ducting in Khalidiya Towers, Al Khalidiyah by The MELLS. Galvanised steel duct is folded from zinc coated sheet, joined with flanges and gaskets, sealed, hung from the slab and then wrapped in insulation on site. A supervisor visits first, and the written quotation follows before any work begins.
- Quotation
- Written, after a visit
- Response
- By appointment
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday

Galvanised Steel Ducting at a glance
| Service | Galvanised Steel Ducting |
|---|---|
| Location | Khalidiya Towers, Al Khalidiyah, Abu Dhabi |
| Property types | Apartments |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | One to three days for most villas and fit out units |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | A measured test for every job, with photographs before and after |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Visits in Abu Dhabi by appointment, Monday to Saturday |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 55 444 0084 or email contact@themells.ae |
What is included
AC ducting sized, fabricated and installed for villas, apartments, offices, shops and restaurants, with joints sealed, ducts insulated and airflow balanced. A ducted AC is only as good as the ductwork hidden above the ceiling. Ducts that are too small are noisy and starve the far rooms, and in Abu Dhabi humidity any gap in the insulation sweats and drips onto the ceiling below. Our own technicians work out the airflow each room needs, then fabricate, hang, seal and insulate the ducts and balance the system before handover.
- Sheet gauge matched to the duct width and system pressure
- Sections joined with gasketed flanges and corner bolts
- Wide ducts cross braced or stiffened to stop drumming
- Cut edges treated with zinc rich paint against rust
How we carry out galvanised steel ducting
Sheet is cut and folded into rectangular sections with a locked seam along the length. Flanges are fitted to each end, a gasket goes between them, and the corners are bolted with clips along the sides. Wide panels are cross braced or given stiffening ribs. Sections are lifted onto threaded rod hangers with angle supports underneath, levelled and joined. Every seam is brushed with duct sealant before the insulation and its vapour barrier are wrapped round the outside and taped.
Steel duct itself rarely fails. What fails is the work around it. Cut edges and scratched zinc rust if left bare, especially near the coast where salt in the air speeds it up. Insulation that stops short of the flanges leaves a cold strip that sweats. Hangers spaced too far apart let a long run sag and pull its joints open. For exposed ducts in shops and cafes the finish matters as well, so the site visit asks whether the duct will be seen or hidden.
How it works
The same method on every job, so the result does not depend on who is on shift.
- Survey and diagnosis. A technician inspects the system or surface, takes readings and photographs, and explains what was found in plain language.
- Written quotation. You receive a written quotation against a defined scope before any work starts. Anything outside that scope is quoted separately.
- Protected, supervised work. The work area is protected and isolated, and the job is carried out by our own technicians under a named supervisor.
- Testing. Every job ends with a measured test suited to the discipline, so the result is a reading and a photograph and not an opinion.
- Report and warranty. The completed report reaches you within the hour. Any failed point is put right free of charge within 48 hours.
Talk to a supervisor about galvanised steel ducting today.
Why choose The MELLS for galvanised steel ducting
What an ordinary job leaves out, and what you can hold us to.
| Point | An ordinary job | The MELLS |
|---|---|---|
| Quotation | A figure over the phone, with extras added on the day | A written quotation after a site visit, and nothing added on the day |
| Team | Crews supplied through agencies or subcontractors | Crew directly employed by The MELLS, with a named supervisor |
| Method | Parts replaced until the fault goes away | The fault is found, measured and explained before any part is replaced |
| Handover | The job ends when the crew leaves | A measured test for every job, with photographs before and after |
| Aftercare | A return visit is charged | A failed check is put right free of charge within 48 hours |
Our commitments on every galvanised steel ducting job
The same standard on a single room or a whole estate.
Written quotation
The scope is fixed in writing before any work begins.
Named supervisor
One person is responsible for your job from the visit to handover.
Checked before handover
A measured test for every job, with photographs before and after.
Put right within 48 hours
If a check fails, we come back and correct it free of charge.
Fully insured
Our work in your home or premises is covered by insurance.
Discreet crews
Uniformed, briefed on your house rules and respectful of your privacy.
Galvanised Steel Ducting in Khalidiya Towers: what we plan for
Established apartment buildings along Khalidiya's streets, many with shops or offices on the lower floors and a mix of older and newer interiors. Tower rules on permits, service lifts and working hours apply even to a short visit, and we arrange all three.
Many Khalidiya towers run on central chilled water with a fan coil unit in each room. We clean coils and filters, flush condensate drains and check thermostats, and anything that belongs to the building plant is reported to building management.
Every tower needs a work permit from building management and a service lift booking before a crew can start. Khalidiya Village has gated security, so the resident registers our team ahead of time. What each building asks for is identified at the site visit and we prepare the paperwork.
What your quotation depends on
A quotation for galvanised steel ducting in Khalidiya Towers, Al Khalidiyah follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Size and type of the system or surface
- Present condition and ease of access
- Parts and materials specified
- One visit or a retained contract
Related AC Ducting & Duct Installation services in Khalidiya Towers
Each one has its own scope and method.
AC Duct Installation
Duct Fabrication
Duct Replacement
Duct Repair and Sealing
Duct Insulation
Flexible Duct Installation
Grille and Diffuser Installation
Kitchen Exhaust Ducting
Bathroom Exhaust Fan and Ducting
Fresh Air Ducting
Dryer Vent Ducting
Duct Modification for Fit Out
Pre Insulated Ducting
Volume Dampers and Air Balancing
Duct Leak Detection
AC Duct Camera Inspection
Fresh Air Duct Cleaning
Dryer Vent Cleaning
Duct Acoustic Lining Replacement
Nearby in Al Khalidiyah
Questions about galvanised steel ducting in Khalidiya Towers
What does galvanised steel ducting include?
Galvanised steel duct is folded from zinc coated sheet, joined with flanges and gaskets, sealed, hung from the slab and then wrapped in insulation on site. The work includes sheet gauge matched to the duct width and system pressure; sections joined with gasketed flanges and corner bolts; wide ducts cross braced or stiffened to stop drumming.
Can steel ducts be left exposed as a design feature?
Yes, and it is a common request. Round spiral duct or neatly made rectangular duct is often left visible in cafes, shops and studios. Exposed duct is either insulated on the inside or made double walled, since bare cold metal would sweat in a humid room.
Does galvanised duct rust in Abu Dhabi?
The zinc coating protects it well in a dry void. Rust starts where the coating is cut or scratched and where condensation sits on the metal for long periods. Treating cut edges and keeping the insulation sealed prevents both.
How much does galvanised steel ducting cost in Khalidiya Towers, Al Khalidiyah?
We do not publish prices, because no two jobs are the same. The main factors: size and type of the system or surface; present condition and ease of access. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides galvanised steel ducting in Khalidiya Towers, Al Khalidiyah?
The MELLS provides galvanised steel ducting in Khalidiya Towers, Al Khalidiyah, Abu Dhabi. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.
How long does galvanised steel ducting take?
Typically one to three days for most villas and fit out units. The time for your property is confirmed with the quotation.
Does the ceiling have to come down?
Not always. Tile ceilings lift out and go back. In a gypsum ceiling we cut openings where the work is and close them afterwards, leaving access panels under the unit and at the dampers.
Do you install AC ducting in Khalidiya Towers, Al Khalidiyah?
Yes. We install, replace and alter AC ducting in villas, apartments, offices, shops and restaurants across Abu Dhabi. A site visit measures the ceiling void and the AC unit before the scope is put in writing.
Why is water dripping from the ceiling under my AC duct?
Most often the insulation or its vapour barrier has a gap, so humid air reaches the cold metal and condenses. A blocked drain line can look the same from below, so we check both before any repair is proposed.
Do you arrange the building permit in Khalidiya Towers, Al Khalidiyah?
Yes. Most buildings ask contractors for a work permit, trade licence, insurance and staff IDs, and a service lift booking. We submit all of it for you.
Do you work in Khalidiya Village as well as the towers?
Yes. Khalidiya Village homes are handled as house projects with gardens and pools in scope, while tower apartments are planned around the building permit and the lift booking.
How do I choose a company for galvanised steel ducting in Khalidiya Towers, Al Khalidiyah?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (a measured test for every job, with photographs before and after) and puts right any failed check free of charge within 48 hours.
How are visits to Khalidiya Towers, Al Khalidiyah arranged?
Visits in Abu Dhabi are booked by appointment between 08:00 and 19:00, Monday to Saturday. Call or send the form and we agree the earliest time a supervisor can come to you.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.
