Book a site visitCall us

Al Khalidiyah

Duct Fabrication in Khalidiya Towers, Al Khalidiyah

Duct sections, bends, reducers and plenum boxes are cut and formed to site measurements, from galvanised sheet or pre insulated panel, then labelled for each run. The MELLS carries this out in Khalidiya Towers, Al Khalidiyah with its own directly employed team and a named supervisor. Book a site visit and you receive a written quotation before any work begins.

Quotation
Written, after a visit
Response
By appointment
Quality checks
14 on every job
Service
Gold rated

5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday

Duct Fabrication in Khalidiya Towers, Al Khalidiyah, The MELLS Property Care

Book a site visit

A supervisor from The MELLS visits, looks at the work and sends you a written quotation. Visits across Dubai and Abu Dhabi, Monday to Saturday.

Or send it on WhatsApp

No obligation. We call you to confirm the time. Prefer to talk? +971 55 444 0084

Duct Fabrication at a glance

ServiceDuct Fabrication
LocationKhalidiya Towers, Al Khalidiyah, Abu Dhabi
Property typesApartments
QuotationIn writing, after a site visit and before any work begins
Typical durationOne to three days for most villas and fit out units
TeamCrew directly employed by The MELLS, with a named supervisor
Quality checkA measured test for every job, with photographs before and after
If a check failsIt is put right free of charge within 48 hours
ResponseVisits in Abu Dhabi by appointment, Monday to Saturday
Hours08:00 to 19:00, Monday to Saturday
BookingBook a site visit on this page, call +971 55 444 0084 or email contact@themells.ae

What is included

AC ducting sized, fabricated and installed for villas, apartments, offices, shops and restaurants, with joints sealed, ducts insulated and airflow balanced. A ducted AC is only as good as the ductwork hidden above the ceiling. Ducts that are too small are noisy and starve the far rooms, and in Abu Dhabi humidity any gap in the insulation sweats and drips onto the ceiling below. Our own technicians work out the airflow each room needs, then fabricate, hang, seal and insulate the ducts and balance the system before handover.

How we carry out duct fabrication

Fabrication begins with a tape measure in the ceiling void, not with a catalogue. Each run is drawn with its lengths, offsets and changes of size, and a cutting list is made from the drawing. Galvanised sheet is cut, folded and closed with a locked seam, and flanges are fitted to the ends. Pre insulated panel is cut with a grooving tool, folded into a box, then glued and taped along the seam. Bends are made with a generous radius or fitted with turning vanes so the air does not tumble.

Poor fabrication shows up as noise and lost airflow. A sharp square bend with no vanes, or a sudden step down in size, makes the duct rumble and whistle. Thin sheet on a wide duct drums every time the fan starts unless it is cross braced. In Abu Dhabi villas the voids are often shallow and crowded with beams, so off the shelf fittings rarely fit and the pieces have to be made to suit. The site visit measures every obstruction before anything is cut.

How it works

The same method on every job, so the result does not depend on who is on shift.

  1. Survey and diagnosis. A technician inspects the system or surface, takes readings and photographs, and explains what was found in plain language.
  2. Written quotation. You receive a written quotation against a defined scope before any work starts. Anything outside that scope is quoted separately.
  3. Protected, supervised work. The work area is protected and isolated, and the job is carried out by our own technicians under a named supervisor.
  4. Testing. Every job ends with a measured test suited to the discipline, so the result is a reading and a photograph and not an opinion.
  5. Report and warranty. The completed report reaches you within the hour. Any failed point is put right free of charge within 48 hours.

Talk to a supervisor about duct fabrication today.

Why choose The MELLS for duct fabrication

What an ordinary job leaves out, and what you can hold us to.

PointAn ordinary jobThe MELLS
QuotationA figure over the phone, with extras added on the dayA written quotation after a site visit, and nothing added on the day
TeamCrews supplied through agencies or subcontractorsCrew directly employed by The MELLS, with a named supervisor
MethodParts replaced until the fault goes awayThe fault is found, measured and explained before any part is replaced
HandoverThe job ends when the crew leavesA measured test for every job, with photographs before and after
AftercareA return visit is chargedA failed check is put right free of charge within 48 hours

Our commitments on every duct fabrication job

The same standard on a single room or a whole estate.

Duct Fabrication in Khalidiya Towers: what we plan for

Established apartment buildings along Khalidiya's streets, many with shops or offices on the lower floors and a mix of older and newer interiors. Tower rules on permits, service lifts and working hours apply even to a short visit, and we arrange all three.

Many Khalidiya towers run on central chilled water with a fan coil unit in each room. We clean coils and filters, flush condensate drains and check thermostats, and anything that belongs to the building plant is reported to building management.

Every tower needs a work permit from building management and a service lift booking before a crew can start. Khalidiya Village has gated security, so the resident registers our team ahead of time. What each building asks for is identified at the site visit and we prepare the paperwork.

What your quotation depends on

A quotation for duct fabrication in Khalidiya Towers, Al Khalidiyah follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.

Related AC Ducting & Duct Installation services in Khalidiya Towers

Each one has its own scope and method.

Nearby in Al Khalidiyah

Questions about duct fabrication in Khalidiya Towers

What does duct fabrication include?

Duct sections, bends, reducers and plenum boxes are cut and formed to site measurements, from galvanised sheet or pre insulated panel, then labelled for each run. The work includes site measured and a cutting list drawn up for each run; sheet cut, folded and seamed, or panel grooved and glued; bends, reducers and take offs made to the measured angles.

Can you make a duct piece to match an existing system?

We can. The existing duct, its flange type and the insulation thickness are measured, and the new section is made to join it. A single reducer, an offset round a beam or a new plenum box for a larger diffuser are all common requests.

What thickness of sheet do you use?

It depends on the width of the duct and the pressure the fan produces. Wider ducts need heavier sheet and stiffening so the sides do not drum. The gauge for each run is listed in the written quotation.

How much does duct fabrication cost in Khalidiya Towers, Al Khalidiyah?

We do not publish prices, because no two jobs are the same. The main factors: size and type of the system or surface; present condition and ease of access. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.

Who provides duct fabrication in Khalidiya Towers, Al Khalidiyah?

The MELLS provides duct fabrication in Khalidiya Towers, Al Khalidiyah, Abu Dhabi. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.

How long does duct fabrication take?

Typically one to three days for most villas and fit out units. The time for your property is confirmed with the quotation.

Does the ceiling have to come down?

Not always. Tile ceilings lift out and go back. In a gypsum ceiling we cut openings where the work is and close them afterwards, leaving access panels under the unit and at the dampers.

Do you install AC ducting in Khalidiya Towers, Al Khalidiyah?

Yes. We install, replace and alter AC ducting in villas, apartments, offices, shops and restaurants across Abu Dhabi. A site visit measures the ceiling void and the AC unit before the scope is put in writing.

Why is water dripping from the ceiling under my AC duct?

Most often the insulation or its vapour barrier has a gap, so humid air reaches the cold metal and condenses. A blocked drain line can look the same from below, so we check both before any repair is proposed.

Do you arrange the building permit in Khalidiya Towers, Al Khalidiyah?

Yes. Most buildings ask contractors for a work permit, trade licence, insurance and staff IDs, and a service lift booking. We submit all of it for you.

Do you work in Khalidiya Village as well as the towers?

Yes. Khalidiya Village homes are handled as house projects with gardens and pools in scope, while tower apartments are planned around the building permit and the lift booking.

How do I choose a company for duct fabrication in Khalidiya Towers, Al Khalidiyah?

Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (a measured test for every job, with photographs before and after) and puts right any failed check free of charge within 48 hours.

How are visits to Khalidiya Towers, Al Khalidiyah arranged?

Visits in Abu Dhabi are booked by appointment between 08:00 and 19:00, Monday to Saturday. Call or send the form and we agree the earliest time a supervisor can come to you.

Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.

Other services in Khalidiya Towers

Deep Cleaning in Khalidiya Towers

AC & Duct Cleaning in Khalidiya Towers

AC Installation in Khalidiya Towers

AC Maintenance & Repair in Khalidiya Towers

Plumbing Services in Khalidiya Towers

Electrician Services in Khalidiya Towers

Lights Fixing & Lighting Installation in Khalidiya Towers

Snagging & Handover Inspection in Khalidiya Towers

Handyman Services in Khalidiya Towers

Packers & Movers in Khalidiya Towers

Technical & MEP Maintenance in Khalidiya Towers

Pest Control in Khalidiya Towers

Other communities

Duct Fabrication in Saadiyat Island

Duct Fabrication in Hidd Al Saadiyat

Duct Fabrication in Jubail Island

Duct Fabrication in Ramhan Island

Duct Fabrication in Fahid Island

Duct Fabrication in Hudayriyat Island

Duct Fabrication in Al Jurf

Duct Fabrication in Nurai Island

Duct Fabrication in Yas Island

Duct Fabrication in Al Reem Island

Duct Fabrication in Al Maryah Island

Duct Fabrication in Masdar City

Duct Fabrication in Al Raha Beach

Duct Fabrication in Al Raha Gardens

Duct Fabrication in Al Raha Golf Gardens

Duct Fabrication in Khalifa City

Duct Fabrication in Al Forsan Village

Duct Fabrication in Sas Al Nakhl Village

Duct Fabrication in Bloom Gardens

Duct Fabrication in Al Maqtaa

Duct Fabrication in Al Bateen

Duct Fabrication in Corniche Road

Duct Fabrication in Marina & Breakwater

Duct Fabrication in Al Mushrif

Duct Fabrication in Al Karamah

Duct Fabrication in Al Rawdah

Duct Fabrication in Embassies District

Duct Fabrication in Al Qurm

Duct Fabrication in every community

This community

Everything we do in Al Khalidiyah

Everything we do in Khalidiya Towers

Who we do this for

AC Ducting & Duct Installation for private residences

AC Ducting & Duct Installation for offices and corporate premises

AC Ducting & Duct Installation for boutiques and retail units

AC Ducting & Duct Installation for hotels, restaurants and wellness venues

AC Ducting & Duct Installation for clinics and medical centres

AC Ducting & Duct Installation for restaurants, cafes and commercial kitchens

Book a site visit. We look at the work and send a written quotation.