Corniche Road
Snagging & Handover Inspection in Bay Tower, Corniche Road
Snagging and handover inspection for new villas, townhouses and apartments: every room checked before you accept the keys, every defect listed and photographed for the developer, and a re inspection once the list has been fixed. The MELLS carries this out in Bay Tower, Corniche Road with its own directly employed team and a named supervisor. Book a site visit and you receive a written quotation before any work begins.
- Quotation
- Written, after a visit
- Response
- To your handover date
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday
Snagging & Handover Inspection at a glance
| Service | Snagging & Handover Inspection |
|---|---|
| Also searched as | Snagging company in Bay Tower, Corniche Road, snagging inspection in Bay Tower, Corniche Road, property snagging in Bay Tower, Corniche Road |
| Location | Bay Tower, Corniche Road, Abu Dhabi |
| Property types | Apartments |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | Half a day for an apartment, one full day for most villas, with the report within 48 hours |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | A measured test for every job, with photographs before and after |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Booked to the developer's inspection or handover date |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 55 444 0084 or email contact@themells.ae |
What is included
A new home is handed over with defects the eye misses in a short walk round: a door that binds, a hollow tile, a slow drain, a hairline crack, an AC that cools one room and not the next. Once the handover form is signed, getting them fixed is slower. The MELLS walks the home room by room with a written checklist, a moisture meter, a thermal camera and a spirit level, lists and photographs every defect, and sends a clear report you can hand to the developer. When the developer says the list is done, we come back and check each item again.
- Walls, ceilings and floors checked under raking light for cracks, hollows, chips and uneven joints
- Doors, windows, wardrobes and kitchen cabinets opened, closed and checked for alignment and seals
- Tiles tapped for hollow spots, grout and silicone checked in every wet area
- Taps run, drains tested for flow and leaks, water heaters and pressure checked
- Sockets, switches and lights tested, the distribution board labelled and checked
- AC cooling checked room by room, with drain lines and grilles inspected
- Thermal imaging and moisture readings on walls, ceilings and around wet areas
- A written report with photographs and locations, ready for the developer, and a re inspection after repair
How it works
The same method on every job, so the result does not depend on who is on shift.
- Booking against your handover date. You send the developer's inspection or handover date, and the inspection is planned for that slot, with the floor plan and specification if you have them.
- Room by room inspection. The inspector works through every room, the outside areas and the building services with a written checklist, a moisture meter, a thermal camera and a spirit level.
- Defects numbered and photographed. Each defect is numbered, located on the plan and photographed, so the developer's team can find it without guesswork.
- Report within 48 hours. The written report reaches you within 48 hours, in a format you can send straight to the developer.
- Re inspection. When the developer says the list is done, every item is checked again and anything still open is recorded in an updated report.
Talk to a supervisor about snagging & handover inspection today.
Why choose The MELLS for snagging & handover inspection
What an ordinary job leaves out, and what you can hold us to.
| Point | An ordinary job | The MELLS |
|---|---|---|
| Quotation | A figure over the phone, with extras added on the day | A written quotation after a site visit, and nothing added on the day |
| Team | Crews supplied through agencies or subcontractors | Crew directly employed by The MELLS, with a named supervisor |
| Method | Parts replaced until the fault goes away | The fault is found, measured and explained before any part is replaced |
| Handover | The job ends when the crew leaves | A measured test for every job, with photographs before and after |
| Aftercare | A return visit is charged | A failed check is put right free of charge within 48 hours |
Our commitments on every snagging & handover inspection job
The same standard on a single room or a whole estate.
Written quotation
The scope is fixed in writing before any work begins.
Named supervisor
One person is responsible for your job from the visit to handover.
Checked before handover
A measured test for every job, with photographs before and after.
Put right within 48 hours
If a check fails, we come back and correct it free of charge.
Fully insured
Our work in your home or premises is covered by insurance.
Discreet crews
Uniformed, briefed on your house rules and respectful of your privacy.
Snagging & Handover Inspection in Bay Tower: what we plan for
Residential towers facing the Corniche beach, with sea views across the road and balconies that take wind, salt and sand every day. In an apartment building we submit the work permit, book the service lift and bring compact equipment that fits it.
Most Corniche towers supply chilled water to fan coil units in each apartment. Coils, trays and filters are cleaned, drain lines flushed and the thermostat checked, so the unit stops dripping onto ceilings and smelling stale.
Every tower on the Corniche needs a work permit from building management and a booked service lift before work starts. Parking for service vans is limited, so loading times are agreed with the building. These rules are identified at the site visit, and we prepare the paperwork the building asks for.
What your quotation depends on
A quotation for snagging & handover inspection in Bay Tower, Corniche Road follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Size and type of the system or surface
- Present condition and ease of access
- Parts and materials specified
- One visit or a retained contract
Snagging & Handover Inspection services in Bay Tower
Each one has its own scope and method.
Nearby in Corniche Road
Questions about snagging & handover inspection in Bay Tower
What does snagging & handover inspection include?
Snagging and handover inspection for new villas, townhouses and apartments: every room checked before you accept the keys, every defect listed and photographed for the developer, and a re inspection once the list has been fixed. The work includes walls, ceilings and floors checked under raking light for cracks, hollows, chips and uneven joints; doors, windows, wardrobes and kitchen cabinets opened, closed and checked for alignment and seals; tiles tapped for hollow spots, grout and silicone checked in every wet area.
How much does snagging & handover inspection cost in Bay Tower, Corniche Road?
We do not publish prices, because no two jobs are the same. The main factors: size and type of the system or surface; present condition and ease of access. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides snagging & handover inspection in Bay Tower, Corniche Road?
The MELLS provides snagging & handover inspection in Bay Tower, Corniche Road, Abu Dhabi. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.
How long does snagging & handover inspection take?
Typically Half a day for an apartment, one full day for most villas, with the report within 48 hours. The time for your property is confirmed with the quotation.
Do you check the work after the developer fixes it?
Yes. A re inspection checks each item on the list again and records anything still open.
Can you inspect before the defects liability period ends?
Yes. An inspection a month or two before the developer's liability period ends catches defects that appeared after you moved in, while they are still covered.
Can you clean the home after snagging?
Yes. Snagging, post handover deep cleaning and an AC clean are often booked together before furniture arrives.
Do you arrange the building permit in Bay Tower, Corniche Road?
Yes. Most buildings ask contractors for a work permit, trade licence, insurance and staff IDs, and a service lift booking. We submit all of it for you.
What days do you work on the Corniche?
Corniche appointments run Monday to Saturday between 08:00 and 19:00, subject to the building's own permitted hours for contractors, which we confirm before booking.
How do I choose a company for snagging & handover inspection in Bay Tower, Corniche Road?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (a measured test for every job, with photographs before and after) and puts right any failed check free of charge within 48 hours.
How are visits to Bay Tower, Corniche Road arranged?
Visits in Abu Dhabi are booked by appointment between 08:00 and 19:00, Monday to Saturday. Call or send the form and we agree the earliest time a supervisor can come to you.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.