Emirates Hills
Exterior Texture Coating in Springs 14, Dubai
The MELLS provides exterior texture coating in Springs 14, Dubai with its own directly employed team. Exterior texture coating puts a thick, flexible acrylic layer over villa render, bridging hairline cracks and shedding rain and irrigation spray while staying breathable. We visit the property first and confirm the scope in a written quotation.
- Quotation
- Written, after a visit
- Response
- 2 hours in Dubai
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday

Exterior Texture Coating at a glance
| Service | Exterior Texture Coating |
|---|---|
| Location | Springs 14, Dubai |
| Property types | Townhouses and villas |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | Usually one to three days, confirmed with the quotation |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | Wet film thickness checked on every coat and an adhesion test at handover |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Two hours in Dubai for urgent work, planned work within 48 hours |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 55 444 0084 or email contact@themells.ae |
What is included
Interior and exterior painting by our own painters, with surfaces properly prepared, furniture fully protected and wet film thickness checked on every coat. A good paint finish is mostly preparation. Dubai walls move with heat, hairline cracks open at ceiling joints, and coastal air and irrigation mark exterior walls within a few seasons. We repair and prime before we paint, apply the system named in your quotation and leave the home clean enough to move straight back into.
- Walls pressure washed and chalky paint stabilised
- Cracks opened, filled and meshed where they are active
- Alkali resistant primer applied to the full elevation
- Texture sprayed or rolled, then sealed with a top coat
How we carry out exterior texture coating
The elevation is scaffolded or reached from a platform, then pressure washed to remove dust, salts and loose paint. Chalking surfaces are bound with a stabilising primer. Cracks are cut open, filled with an exterior filler and, where they are moving, bridged with mesh. An alkali resistant primer follows. The texture coat, a heavy bodied acrylic carrying fine aggregate, is sprayed through a hopper gun or rolled with a coarse sleeve, one full wall at a time. An elastomeric or pure acrylic top coat finishes it.
West and south faces in Dubai reach very high surface temperatures, and render expands and contracts every day until it cracks at window corners and along the junction of block and concrete. Fine sand then abrades the paint and dust sticks to it. Coating a hot wall causes the texture to skin over and blister, so work follows the shade around the house. Dark colours fade fastest. The site visit checks for hollow render and damp at the base, and identifies any colour approval the master developer asks for.
How it works
The same method on every job, so the result does not depend on who is on shift.
- Survey, colour and written scope. We measure, test the existing coating and agree colours, sheen and the number of coats. The written quotation names the paint system and the scope.
- Protection. Furniture is moved and wrapped, floors are covered edge to edge, and switches, handles and light fittings are masked or removed.
- Surface preparation. Walls are washed, flaking paint is scraped back, cracks are opened and filled, and everything is sanded flat. Damp or salt affected areas are treated before any paint goes on.
- Primer and finish coats. A sealer or primer suited to the substrate is followed by two finish coats. Wet film thickness is checked on every coat.
- Snagging and handover. We inspect in daylight with you, touch up, clean down and hand over a paint schedule listing brand, colour codes and batch numbers for future touch ups.
Talk to a supervisor about exterior texture coating today.
Why choose The MELLS for exterior texture coating
What an ordinary job leaves out, and what you can hold us to.
| Point | An ordinary job | The MELLS |
|---|---|---|
| Quotation | A figure over the phone, with extras added on the day | A written quotation after a site visit, and nothing added on the day |
| Team | Crews supplied through agencies or subcontractors | Crew directly employed by The MELLS, with a named supervisor |
| Preparation | Paint rolled over cracks, dust and damp | Cracks filled, surfaces sanded and primed before the first coat |
| Handover | The job ends when the crew leaves | Wet film thickness checked on every coat and an adhesion test at handover |
| Aftercare | A return visit is charged | A failed check is put right free of charge within 48 hours |
Our commitments on every exterior texture coating job
The same standard on a single room or a whole estate.
Written quotation
The scope is fixed in writing before any work begins.
Named supervisor
One person is responsible for your job from the visit to handover.
Checked before handover
Wet film thickness checked on every coat and an adhesion test at handover.
Put right within 48 hours
If a check fails, we come back and correct it free of charge.
Fully insured
Our work in your home or premises is covered by insurance.
Discreet crews
Uniformed, briefed on your house rules and respectful of your privacy.
Exterior Texture Coating in Springs 14: what we plan for
The Springs is made up of townhouses and compact villas grouped around small lakes. In a townhouse this is normally a short visit, and it can be combined with other work in the same booking.
Higher humidity beside water calls for mould resistant paint in bathrooms and careful sealing outside. Many villas in The Springs, The Meadows and The Lakes are now around twenty years old, so hairline cracks, faded exterior paint and irrigation stained boundary walls are common. In Emirates Hills itself, interiors often include decorative plaster, timber panelling and gilded details that are masked or restored by hand. Exterior colours follow the palette approved by the community.
Entry is through security gates and contractors are registered in advance by the resident. Exterior work normally needs approval from community management, and working hours are restricted to protect residents.
What your quotation depends on
A quotation for exterior texture coating in Springs 14, Dubai follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Wall and ceiling area and ceiling height
- Condition of the surface and how much repair is needed
- Paint system, sheen and number of coats
- Colour changes, feature finishes and access equipment
Related Painting Services services in Springs 14
Each one has its own scope and method.
Villa Painting
Interior Painting
Exterior Painting
Wall Painting
Antifungal Wall Painting
Facade Painting
Fence Painting
Move Out Painting
Office Painting
Ceiling Painting
Wall Crack and Plaster Repair
Feature Walls
Decorative and Textured Finishes
Wood and Door Painting
Kitchen Cabinet Painting
Boundary Wall Painting
Metal Gate and Railing Painting
Nursery and Kids Room Painting
Bedroom Painting
Living Room Painting
Bathroom Painting
Kitchen Painting
Majlis Painting
Staircase and Hallway Painting
Townhouse Painting
Single Room Painting
Paint Touch up
Wall Putty and Skim Coating
Damp Wall Treatment
Venetian Plaster and Stucco
Limewash and Mineral Paint
Two Tone and Colour Block Walls
Paint Colour Consultation
Airless Spray Painting
Skirting and Trim Painting
Pergola and Timber Staining
Garage Floor Painting
Paint Stripping and Removal
House Painting
Roof Painting
Paint Colour Matching
Water Damage Paint Repair
Mansion Painting
Epoxy Flooring
Nearby in Emirates Hills
Questions about exterior texture coating in Springs 14
What does exterior texture coating include?
Exterior texture coating puts a thick, flexible acrylic layer over villa render, bridging hairline cracks and shedding rain and irrigation spray while staying breathable. The work includes walls pressure washed and chalky paint stabilised; cracks opened, filled and meshed where they are active; alkali resistant primer applied to the full elevation.
Does a texture coat stop cracks from showing?
It hides and bridges hairline cracks well, because the coating is thick and slightly elastic. Wider or moving cracks must be repaired and meshed first, or they print through within a season. Structural cracks are a separate matter and are pointed out at the site visit.
Can the colour of my villa be changed?
Often it can, within the palette your community allows. Many master developers keep a list of permitted exterior colours and ask for a request before work begins. Whatever approval applies is identified at the site visit and The MELLS prepares the paperwork for it.
How much does exterior texture coating cost in Springs 14, Dubai?
We do not publish prices, because no two jobs are the same. The main factors: wall and ceiling area and ceiling height; condition of the surface and how much repair is needed. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides exterior texture coating in Springs 14, Dubai?
The MELLS provides exterior texture coating in Springs 14, Dubai. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.
How long does exterior texture coating take?
Usually one to three days, confirmed with the quotation.
How do you protect furniture and floors?
Furniture is moved to the centre of the room and wrapped. Floors are covered edge to edge, and fittings are masked or removed. The crew cleans down every day.
Do you repair cracks and damp patches before painting?
Yes. Cracks are opened, filled and sanded, and damp or salt affected plaster is treated and sealed first. Painting over a defect only hides it for a few months.
How long before the paint is fully dry?
Water based emulsion is touch dry in about an hour and can be recoated in around four hours. It reaches full hardness over two to four weeks, so avoid scrubbing new walls in that time.
How do your crews get access to Springs 14, Dubai?
Entry is through security gates and contractors are registered in advance by the resident. Exterior work normally needs approval from community management, and working hours are restricted to protect residents.
Can you work in homes with a house manager or staff?
Yes. The supervisor coordinates directly with your house manager, and the programme is agreed room by room.
How do I choose a company for exterior texture coating in Springs 14, Dubai?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (wet film thickness checked on every coat and an adhesion test at handover) and puts right any failed check free of charge within 48 hours.
Can you come to Springs 14, Dubai at short notice?
Yes. Crews travel from our Barsha Heights base, and urgent work in Dubai is attended within two hours between 08:00 and 19:00, Monday to Saturday.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.
