Painting Services
Two Tone and Colour Block Walls in Al Barsha & Barsha Heights
The MELLS provides two tone and colour block walls in Al Barsha with its own directly employed team. Two tone and colour block walls are set out by laser level, masked with fine line tape and sealed along the tape edge so the line between the colours stays crisp. Book a site visit and you receive a written quotation before any work begins.
- Quotation
- Written, after a visit
- Response
- 2 hours in Dubai
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday
Two Tone and Colour Block Walls at a glance
| Service | Two Tone and Colour Block Walls |
|---|---|
| Location | Al Barsha & Barsha Heights, Dubai |
| Property types | Villas and apartments |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | Usually one to three days, confirmed with the quotation |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | Wet film thickness checked on every coat and an adhesion test at handover |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Two hours in Dubai for urgent work, planned work within 48 hours |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 55 444 0084 or email contact@themells.ae |
What is included
Interior and exterior painting by our own painters, with surfaces properly prepared, furniture fully protected and wet film thickness checked on every coat. A good paint finish is mostly preparation. Dubai walls move with heat, hairline cracks open at ceiling joints, and coastal air and irrigation mark exterior walls within a few seasons. We repair and prime before we paint, apply the system named in your quotation and leave the home clean enough to move straight back into.
- Line height or block shape marked with a laser level
- Lighter colour applied first and left to dry fully
- Tape edge sealed with the base colour to stop bleed
- Tape pulled back on itself while the last coat is still soft
How we carry out two tone and colour block walls
The lighter colour goes on first, across the whole wall and past where the line will fall, and it is left to dry for at least a day so tape will not lift it. The line is then set out with a laser level, since floors and ceilings are seldom true, and marked lightly in pencil. Low tack fine line tape is pressed down firmly. A thin coat of the base colour is brushed over the tape edge to seal it, so any bleed is invisible. Two coats of the second colour follow, and the tape is drawn off slowly at a shallow angle.
Bleed under the tape is the classic fault, and it is worse on walls with a roller texture, where paint creeps along the tiny valleys. Tape left on too long tears the film when removed, and tape applied to paint that has not cured pulls it off the wall. A horizontal line measured from an uneven floor will look as though it slopes. At the site visit we mark the proposed line on the wall, check it against door heads, sockets and window sills and agree the sheen for each colour.
How it works
The same method on every job, so the result does not depend on who is on shift.
- Survey, colour and written scope. We measure, test the existing coating and agree colours, sheen and the number of coats. The written quotation names the paint system and the scope.
- Protection. Furniture is moved and wrapped, floors are covered edge to edge, and switches, handles and light fittings are masked or removed.
- Surface preparation. Walls are washed, flaking paint is scraped back, cracks are opened and filled, and everything is sanded flat. Damp or salt affected areas are treated before any paint goes on.
- Primer and finish coats. A sealer or primer suited to the substrate is followed by two finish coats. Wet film thickness is checked on every coat.
- Snagging and handover. We inspect in daylight with you, touch up, clean down and hand over a paint schedule listing brand, colour codes and batch numbers for future touch ups.
Talk to a supervisor about two tone and colour block walls today.
Why choose The MELLS for two tone and colour block walls
What an ordinary job leaves out, and what you can hold us to.
| Point | An ordinary job | The MELLS |
|---|---|---|
| Quotation | A figure over the phone, with extras added on the day | A written quotation after a site visit, and nothing added on the day |
| Team | Crews supplied through agencies or subcontractors | Crew directly employed by The MELLS, with a named supervisor |
| Preparation | Paint rolled over cracks, dust and damp | Cracks filled, surfaces sanded and primed before the first coat |
| Handover | The job ends when the crew leaves | Wet film thickness checked on every coat and an adhesion test at handover |
| Aftercare | A return visit is charged | A failed check is put right free of charge within 48 hours |
Our commitments on every two tone and colour block walls job
The same standard on a single room or a whole estate.
Written quotation
The scope is fixed in writing before any work begins.
Named supervisor
One person is responsible for your job from the visit to handover.
Checked before handover
Wet film thickness checked on every coat and an adhesion test at handover.
Put right within 48 hours
If a check fails, we come back and correct it free of charge.
Fully insured
Our work in your home or premises is covered by insurance.
Discreet crews
Uniformed, briefed on your house rules and respectful of your privacy.
Two Tone and Colour Block Walls in Al Barsha: what we plan for
Al Barsha combines streets of large private villas in Al Barsha 2 and 3 with the apartment buildings of Al Barsha 1 around Mall of the Emirates. Barsha Heights is a district of residential and office towers, and Al Barsha South includes Arjan, Dubai Science Park and the Villa Lantana compounds. The MELLS office is in Barsha Heights.
Sheikh Zayed Road and Hessa Street carry heavy traffic, so an oily film builds on road facing glass and sills. City dust enters through the AC and settles on high ledges. Older villas often have many layers of paint and patched plaster, so preparation takes longer than the painting. We strip loose coatings, fill and sand flat before priming. Road facing exterior walls are degreased before any paint is applied.
Villas are on open streets. Towers in Barsha Heights and Al Barsha 1 need a work permit and a service lift booking, which we arrange.
What your quotation depends on
A quotation for two tone and colour block walls in Al Barsha follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Wall and ceiling area and ceiling height
- Condition of the surface and how much repair is needed
- Paint system, sheen and number of coats
- Colour changes, feature finishes and access equipment
Related Painting Services services in Al Barsha
Each one has its own scope and method.
Villa Painting
Apartment Painting
Interior Painting
Exterior Painting
Wall Painting
Antifungal Wall Painting
Facade Painting
Fence Painting
Move Out Painting
Office Painting
Ceiling Painting
Wall Crack and Plaster Repair
Feature Walls
Decorative and Textured Finishes
Wood and Door Painting
Kitchen Cabinet Painting
Boundary Wall Painting
Metal Gate and Railing Painting
Nursery and Kids Room Painting
Bedroom Painting
Living Room Painting
Bathroom Painting
Kitchen Painting
Majlis Painting
Staircase and Hallway Painting
Townhouse Painting
Penthouse Painting
Single Room Painting
Paint Touch up
Wall Putty and Skim Coating
Damp Wall Treatment
Venetian Plaster and Stucco
Limewash and Mineral Paint
Paint Colour Consultation
Airless Spray Painting
Skirting and Trim Painting
Pergola and Timber Staining
Garage Floor Painting
Exterior Texture Coating
Paint Stripping and Removal
Shop and Showroom Painting
Restaurant and Cafe Painting
Warehouse Painting
Clinic Painting
School and Nursery Painting
Building Corridor and Lobby Painting
Car Park Line Marking
House Painting
Commercial Painting
Building Painting
Roof Painting
Paint Colour Matching
Water Damage Paint Repair
Hotel Painting
Salon and Spa Painting
Gym Painting
Mansion Painting
Studio Apartment Painting
Epoxy Flooring
Two Tone and Colour Block Walls across Al Barsha
Questions about two tone and colour block walls in Al Barsha
What does two tone and colour block walls include?
Two tone and colour block walls are set out by laser level, masked with fine line tape and sealed along the tape edge so the line between the colours stays crisp. The work includes line height or block shape marked with a laser level; lighter colour applied first and left to dry fully; tape edge sealed with the base colour to stop bleed.
At what height should the line between two colours sit?
There is no fixed rule, but a line that meets something already in the room looks deliberate: the top of a door frame, a window sill or a dado height about a third of the way up. We tape a trial line on the wall so you can see it before paint is opened.
Can curves, arches or diagonal blocks be painted?
Curved and angled shapes are done with flexible fine line tape or by a steady hand and a good sash brush. Arches are drawn with a string and pencil from a fixed centre point. They take longer than straight lines, and the quotation allows for the setting out time.
How much does two tone and colour block walls cost in Al Barsha?
We do not publish prices, because no two jobs are the same. The main factors: wall and ceiling area and ceiling height; condition of the surface and how much repair is needed. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides two tone and colour block walls in Al Barsha?
The MELLS provides two tone and colour block walls in Al Barsha, Dubai. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.
How long does two tone and colour block walls take?
Usually one to three days, confirmed with the quotation.
How do you protect furniture and floors?
Furniture is moved to the centre of the room and wrapped. Floors are covered edge to edge, and fittings are masked or removed. The crew cleans down every day.
Do you repair cracks and damp patches before painting?
Yes. Cracks are opened, filled and sanded, and damp or salt affected plaster is treated and sealed first. Painting over a defect only hides it for a few months.
How long before the paint is fully dry?
Water based emulsion is touch dry in about an hour and can be recoated in around four hours. It reaches full hardness over two to four weeks, so avoid scrubbing new walls in that time.
How do your crews get access to Al Barsha?
Villas are on open streets. Towers in Barsha Heights and Al Barsha 1 need a work permit and a service lift booking, which we arrange.
How quickly can you reach Al Barsha?
Our office is in Barsha Heights, so urgent calls in Al Barsha are among the fastest we attend, usually well inside two hours.
How do I choose a company for two tone and colour block walls in Al Barsha?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (wet film thickness checked on every coat and an adhesion test at handover) and puts right any failed check free of charge within 48 hours.
Can you come to Al Barsha at short notice?
Yes. Crews travel from our Barsha Heights base, and urgent work in Dubai is attended within two hours between 08:00 and 19:00, Monday to Saturday.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.