Mould Removal & Remediation
Anti Mould Coating in Al Raha Beach
The MELLS provides anti mould coating in Al Raha Beach with its own directly employed team. Stain blocking primer and anti mould paint for bathrooms, kitchens, ceilings and cold walls, applied only once the growth is gone and the surface is dry. We visit the property first and confirm the scope in a written quotation.
- Quotation
- Written, after a visit
- Response
- By appointment
- Quality checks
- 14 on every job
- Service
- Gold rated
5.0 on GoogleFully insuredNo subcontractorsOpen 08:00 to 19:00, Monday to Saturday

Anti Mould Coating at a glance
| Service | Anti Mould Coating |
|---|---|
| Location | Al Raha Beach, Abu Dhabi |
| Property types | Villas and apartments |
| Quotation | In writing, after a site visit and before any work begins |
| Typical duration | Half a day for a single room, and 1 to 3 days where plaster or paint has to dry between stages |
| Team | Crew directly employed by The MELLS, with a named supervisor |
| Quality check | 14 Point Standard signed by the supervisor, with photographs before and after |
| If a check fails | It is put right free of charge within 48 hours |
| Response | Visits in Abu Dhabi by appointment, Monday to Saturday |
| Hours | 08:00 to 19:00, Monday to Saturday |
| Booking | Book a site visit on this page, call +971 58 656 3001 or email contact@themells.ae |
What is included
Mould removal for villas and apartments that begins by finding the moisture source, then removes the growth and treats the surface behind it. Humid Abu Dhabi air meets cold air conditioned walls, ducts and wardrobes, and the condensation feeds mould within weeks, most of all in homes closed up over summer. Mould returns if the moisture remains, so we trace the leak, condensation or ventilation fault first, contain the area, remove the growth and tell you plainly what must be repaired to keep it away.
- Existing growth removed and the surface washed before any coating
- Moisture reading taken to confirm the surface is dry enough to coat
- Stain blocking primer over old water marks and treated patches
- Two coats of anti mould paint in the agreed colour and sheen
How we carry out anti mould coating
A coating is the last step of a mould job, never the first. The growth is HEPA vacuumed and washed off with an antifungal solution, failed paint is scraped back and filled, and the surface is left until a moisture reading shows it is dry. Stain blocking primer then seals in the brown and grey marks that would otherwise ghost through. Two coats of anti mould paint follow. On bathroom and kitchen ceilings we use a finish that can be wiped, since those ceilings will see steam again.
It helps to be clear about what the paint does. It contains an additive that makes the film a poor place for mould to start, which slows regrowth on a surface that only gets damp now and then. It does not dry out a wet wall, stop a leak or make up for an extract fan that does not pull. Over a damp wall it blisters like any other paint, and the mould comes back through it. That is why the quotation lists the moisture repair separately and why we will not coat a surface that still reads wet.
How it works
The same method on every job, so the result does not depend on who is on shift.
- Site visit and written quotation. A supervisor visits, measures and records every room, surface and extra. The written quotation that follows sets out the scope, with no hourly meter and nothing added on the day.
- Protect and prepare. Lifts, floors and furniture are protected and delicate finishes are logged on a surface register before any product is opened.
- Dry before wet, top before bottom. Dust is lifted with HEPA filtered vacuums from ceilings and fittings downwards. Each zone is then wet cleaned with chemistry matched to its finish.
- Detail work and floors. Tracks, switches, skirtings, handles and glass are finished by hand. Floors are machine scrubbed last so nothing is walked back in.
- Inspection and report. The supervisor signs all fourteen checks, photographs the result and sends you the report within the hour.
Talk to a supervisor about anti mould coating today.
Why choose The MELLS for anti mould coating
What an ordinary job leaves out, and what you can hold us to.
| Point | An ordinary job | The MELLS |
|---|---|---|
| Quotation | A figure over the phone, with extras added on the day | A written quotation after a site visit, and nothing added on the day |
| Team | Crews supplied through agencies or subcontractors | Crew directly employed by The MELLS, with a named supervisor |
| Products | One all purpose chemical on every surface | Products matched to marble, wood, brass, crystal and fabric |
| Handover | The job ends when the crew leaves | 14 Point Standard signed by the supervisor, with photographs before and after |
| Aftercare | A return visit is charged | A failed check is put right free of charge within 48 hours |
Our commitments on every anti mould coating job
The same standard on a single room or a whole estate.
Written quotation
The scope is fixed in writing before any work begins.
Named supervisor
One person is responsible for your job from the visit to handover.
Checked before handover
14 Point Standard signed by the supervisor, with photographs before and after.
Put right within 48 hours
If a check fails, we come back and correct it free of charge.
Fully insured
Our work in your home or premises is covered by insurance.
Discreet crews
Uniformed, briefed on your house rules and respectful of your privacy.
Anti Mould Coating in Al Raha Beach: what we plan for
Al Raha Beach is a string of separate waterfront precincts rather than one estate. Al Bandar and Al Muneera hold most of the apartment buildings, set around a marina and a beach promenade, and Al Muneera Island adds townhouses and villas on the water. Al Zeina mixes apartments with podium villas, and Al Raha Lofts, Al Seef and Lamar Residences add further apartment buildings along the canals.
Salt off the Gulf settles on balcony glass and aluminium frames within days, and the onshore breeze drives fine sand into sliding door tracks. Waterfront humidity stays high well into the evening in summer, so mould shows first in bathroom silicone, behind wardrobes on outside walls and around AC supply grilles.
Apartment buildings ask for a work permit from building management and a booked service lift. The island townhouses and Al Zeina villas sit behind security, where the resident registers our crew beforehand. Terrace or facade work may need master community consent, which is checked at the site visit.
What your quotation depends on
A quotation for anti mould coating in Al Raha Beach follows a site visit. The supervisor looks at the points listed here and you receive a written quotation with a defined scope before any work begins. Once you accept it, nothing is added on the day.
- Size of the property and number of rooms
- Condition, and how long since the last deep clean
- Furnished and occupied, or empty
- Extras such as sofas, carpets, mattresses, external glass or outdoor areas
Related Mould Removal & Remediation services in Al Raha Beach
Each one has its own scope and method.
Bathroom Mould Removal
Ceiling Mould Treatment
Wall Mould Treatment
Wardrobe Mould Removal
Mould Inspection and Testing
Mould Repair After a Leak
Black Mould Removal
White Mould Removal
Green Mould Removal
Pink Mould and Shower Slime Removal
Mildew Removal
Bedroom Mould Removal
Kitchen Mould Removal
Window Frame and Sealant Mould Removal
Musty Smell and Damp Odour Removal
Villa Mould Removal
Apartment Mould Removal
Mould Removal After Flooding
Mould Treatment for a Home Closed Over Summer
Yellow Mould Removal
Mould Treatment for New Homes Before Handover
Office and Commercial Mould Removal
Pre Tenancy Mould Check
Mould Prevention Visits
AC Mould Removal
Curtain Mould and Odour Removal
Damp Wall Treatment
Anti Mould Coating across Al Raha Beach
Questions about anti mould coating in Al Raha Beach
What does anti mould coating include?
Stain blocking primer and anti mould paint for bathrooms, kitchens, ceilings and cold walls, applied only once the growth is gone and the surface is dry. The work includes existing growth removed and the surface washed before any coating; moisture reading taken to confirm the surface is dry enough to coat; stain blocking primer over old water marks and treated patches.
Will anti mould paint stop the mould coming back?
It slows regrowth; it does not prevent it on a surface that stays damp. Where the moisture has been dealt with, the coating keeps a bathroom ceiling or a cold wall clean for much longer. Where it has not, mould returns over any paint.
Can the coating go straight over the existing mould?
No. Painting over live growth traps it under the film, and it pushes through within weeks. The mould is removed, the surface washed and dried, and old stains primed first. Only then is the anti mould paint applied.
How much does anti mould coating cost in Al Raha Beach?
We do not publish prices, because no two jobs are the same. The main factors: size of the property and number of rooms; condition, and how long since the last deep clean. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.
Who provides anti mould coating in Al Raha Beach?
The MELLS provides anti mould coating in Al Raha Beach, Abu Dhabi. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 58 656 3001.
How long does anti mould coating take?
Typically half a day for a single room, and 1 to 3 days where plaster or paint has to dry between stages. The time for your property is confirmed with the quotation.
Do you carry out mould removal in Al Raha Beach?
Yes, across Abu Dhabi. Book a site visit and a supervisor inspects the affected rooms and takes moisture readings before any treatment is proposed.
Will the mould come back after treatment?
It will if the moisture that fed it is still there. That is why we find the leak, condensation or ventilation fault first and put in writing what needs fixing.
Why does mould grow in an air conditioned home?
Humid air condenses on cold surfaces, most often around AC grilles, ducts, external walls and closed wardrobes. Homes shut for the summer with the AC switched off are the most exposed.
How do your crews get access to Al Raha Beach?
Apartment buildings ask for a work permit from building management and a booked service lift. The island townhouses and Al Zeina villas sit behind security, where the resident registers our crew beforehand. Terrace or facade work may need master community consent, which is checked at the site visit.
Can you work in the Al Bandar and Al Muneera apartment buildings?
Yes. We apply for the work permit through building management, book the service lift and protect the corridor. Visits in Abu Dhabi are by appointment, Monday to Saturday, 08:00 to 19:00.
How do I choose a company for anti mould coating in Al Raha Beach?
Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (14 Point Standard signed by the supervisor, with photographs before and after) and puts right any failed check free of charge within 48 hours.
How are visits to Al Raha Beach arranged?
Visits in Abu Dhabi are booked by appointment between 08:00 and 19:00, Monday to Saturday. Call or send the form and we agree the earliest time a supervisor can come to you.
Page updated by The MELLS, Damac Executive Heights, Barsha Heights, Dubai.
