Wall Light Installation in Dubai

Wall lights are fixed to solid wall or a backing plate at an agreed height, with the cable chased in or pulled through an existing conduit and the wall made good. The work includes height and spacing marked on the wall and agreed first; wall scanned for pipes and cables before any drilling; cable routed in conduit, a chase or behind joinery.

No. Where a conduit, a ceiling void or a run behind wardrobes gives a route, the wall stays whole. A plug in wall light with a surface cable is another option for rented homes. Chasing is the last choice, and the quotation says where it is needed.

Roughly shoulder height when you sit up in bed, so the light falls on a book and the lamp stays out of your eyes. We mark the spot with you sitting where you read before the back plate goes on.

We do not publish prices, because no two jobs are the same. The main factors: size and type of the system or surface; present condition and ease of access. Book a site visit: a supervisor from The MELLS looks at the work and you receive a written quotation with a defined scope before anything begins.

The MELLS provides wall light installation in Dubai. The work is carried out by people The MELLS employs directly, under a named supervisor, 08:00 to 19:00, Monday to Saturday. To arrange it, book a site visit on this page or call +971 55 444 0084.

Typically 1 to 3 hours for a few fittings, longer for whole rooms. The time for your property is confirmed with the quotation.

Within one room, yes. Warm white suits living rooms and bedrooms, and neutral white suits kitchens and work areas. Two whites on one ceiling look patchy, so we read the colour temperature printed on each lamp before it is fitted.

Yes. Our own technicians replace single fittings and install complete lighting in villas, apartments, offices and shops across Dubai. A site visit confirms the ceiling type, the fixing points and the circuit before the scope is put in writing.

Yes. Have the fitting out of its box at the site visit so we can check its weight, the driver it needs and its rating for the room. If a bathroom or garden fitting is not sealed for that location, we tell you before it goes up.

Four causes account for most flicker: a failing driver, a dimmer that does not suit the lamp, a loose neutral, or a transformer carrying more than it should. We test for them in turn instead of swapping lamps at random, and show you what we found.

Not from the board itself. The weight has to go to the slab or a joist through a fixing rated for the load, with the gypsum only covering it. We open a small access above the position, set the anchor and close the ceiling around the rose.

Towers and malls normally ask for a work permit, and a retail unit has to follow the landlord fit out guide. We identify what applies at the site visit and prepare the paperwork the building or the landlord asks for.

Ask four things: who employs the people who will come, whether the scope is written down before work starts, how the result is checked, and what happens if something is missed. The MELLS uses its own staff, quotes in writing after a site visit, checks every job (a measured test for every job, with photographs before and after) and puts right any failed check free of charge within 48 hours.

Clear access to the units, panels or areas to be worked on and note any faults you have noticed. The supervisor confirms anything else at the site visit.

No. Products, tools and machines come with the crew. Any materials the job needs, such as paint or parts, are listed in the written quotation.

Tell the supervisor at handover or call us. Anything that fails our check is put right free of charge within 48 hours.